Welcome Guest. Please Login or Register. Apr 5th, 2018, 9:52pm
ATTENTION MEMBERS: Conforums will be closing it doors and discontinuing its service on April 15, 2018. Ad-Free has been deactivated. Outstanding Ad-Free credits will be reimbursed to respective payment methods.
If you require a dump of the post on your message board, please come to the support board and request it.
Error in Tutorial?
« Thread started on: Jun 5th, 2014, 09:42am »
This is so minor a complaint and I am so new to this that I wondered about bothering; also I assume that if I am right others have discovered it: on page 10/10 (the last) in Chapter 14 of the Tutorial, the 3rd line reads 'PRINT "Dimension:";N%; I THINK the last item should be I% instead of N%.
Hope I am not making a fool of myself here.
Logged
rtr Guest
Re: Error in Tutorial?
« Reply #1 on: Jun 5th, 2014, 11:32am »
I assume so too, but unfortunately the tutorial's author Peter Nairn has long since disappeared so cannot be consulted. Perhaps we should consider it a 'deliberate mistake' to see if the reader is paying attention!
Logged